You are totaly right! Yes 987455 for the driver side and 987456 passenger side I have done mine last june, could not remember it well, sorry! To not confuse anyone: 2x Self locking M14 nut 985660 for both LCA rear bolts 2 x M12 987455 for driver side 2 x M12 987456 for passenger side From my order i...

240-1992 Classic
Glen Coe Scotland 2012

245 -1979
Crossing North Cap Norway 1996

Have you tried Bildelsbasen in Sweden? A good used one could be the option for this mileage car. Though the shipping cost aren't cheap.

https://en.bildelsbasen.se/?link=list&s ... =125103103

I removed the center bearing, while pushing with the M8 bolt at the back of the Flange, pull down the propeller shaft at the cross brace. I used only one M8 x 30mm bolt to push the Cv joint out that way. 1/2 wrench with an extender and a 24mm socket worked, but i had a counter-hold tool, and then an...

After the CV joint out, the 24mm bolt. At this stage you will need to counter hold the Flange or use a impact gun. There is a seal between the Flange and the Haldex, keep it intact not to use a tool to pry the Flange.

Must have been great fun!!

1438 Volvo / 8 rows / 1 Mile

Meet the Beetles

A friend asked me about advises to buy an old Volvo. After two week of research he came back to visit me with this beautiful 244 from 1979! so glad!

A new connector can be found under the ref: Volvo, Seat 1J0 973 702 2-Pin
If you have the pin extractor it should be easy.

https://www.ebay.fr/itm/VAG-Volvo-Seat- ... 1438.l2649