It takes a lot of time and patience. Once the halves are separated you will see how much plastic is holding onto the capsule. I took a sharp box cutter and scraped away plastic one layer at a time. It took hours. Always cut away from the capsule, not towards. Just in case you slip. There was minimal...

Looks like a snapshot of my life over the past 5 years

ZionXIX wrote: ↑20 Dec 2022, 19:55 So I got my fuel pump assembly delivered today for the xc90 but the top of my fuel pump looks way different than what I received. Here is what mine looks like.
20221218_211000.jpg

Well it turns out that is the level sensor cover

I replaced my fuel pump yesterday and used this tool to do it. Your design works. I field tested it for you. I printed in PETG 0.6mm nozzle at 0.32mm layers and 100% infill. Total print time was about 7 hours. 43 meters and 129g of Total material used at an estimated cost of $3.22 for this particula...

So im planning to rebuild the head with valve replacement and the works. My question is how do I set the timing on the vvt engine since the belt broke?

I like to use the heat shrink crimped connectors with the solder ring inside.

Honestly its not that expensive to buy like 10ft of each vacuum hose size and then replace all the hoses you can find one at a time. You can get some pretty nice high quality silicone hoses on ipd website or even amazon.

I am extremely jealous of that paint quality.

Made some 3d printed clips Doesnt move at all now, worth having 4 visible screws :D Great idea. Could you start a new thread and upload them there or to a public repository like Thingiverse? That would allow everyone access to this simple solution. How are you securing the bottom edge of the tailga...

FireFox31 wrote: ↑27 Mar 2023, 00:13 At the top right of every MVS page, there's a logo saying [url=https://www.fcpeuro.com/?utm_source=Mat ... r%20Button] I want FCP to know that MVS is the primary reason that I spend thousands of dollars with them.

Precisely