A small shrapnel explosion from inside?
Search found 17 matches
- 05 May 2024, 20:46
- Jump to forum
- Jump to topic
Re: How rare is it? 2001 V70 T5M
- 25 Jul 2024, 14:04
- Jump to forum
- Jump to topic
Re: Bad to worse: Cleaned TB, now erratic idle and stalling
Yes, ignatz, running better now, idle is steady and acceleration is much improved.
- 09 Feb 2025, 23:56
- Jump to forum
- Jump to topic
Re: Searching a Turbo für my '06 V70R
After a long search, i got an brand new Turbo.
For better fault chasing i'll keep my other thread updated.
viewtopic.php?p=656438#p656438
For better fault chasing i'll keep my other thread updated.
viewtopic.php?p=656438#p656438
- 18 Feb 2025, 14:32
- Jump to forum
- Jump to topic
Re: Connecting "new" type CVVT reset valve
Thanks for the help and support.
I chopped of the connector from my -03 spares engine and just hooked it up in my car, installed the new solenoid, and it started up just fine
I chopped of the connector from my -03 spares engine and just hooked it up in my car, installed the new solenoid, and it started up just fine
- 18 Aug 2025, 19:33
- Jump to forum
- Jump to topic
Re: Oil Pressure Sensor '04 XC
I received it, but haven’t gotten to it yet. It’s a good sized hex. I’m thinking I’ll get an offset box end wrench with some length. Looks like you have to go in from below.
- 30 Nov 2025, 17:57
- Jump to forum
- Jump to topic
Re: rough idle and acceleration in colder weather
update on this one, turns out my electronic throttle body was toast too. Looks like multiple issues. The new fuel filter and fuel line likely were not the main cause of my rough idle. I replaced the ETB with one from FCP euro, not the official Volvo replacement but I think the Bosch model. Works gre...
- 06 Jan 2026, 09:59
- Jump to forum
- Jump to topic
Re: STOP ENGINE, NO OIL!!!!!! (warning)
Fixed. Cold wet garage floor was fun. There’s about 3” of clearance between the bottom of the pan and the subframe. You can get your hand up there, but hard to rotate it or thread the sensor in blind. It’s somewhere around 23mm, which of course I don’t have. No way a deep socket and ratchet would fi...






