Welcome to MVS If you are looking for advice on what needs maintenance and what goes wrong https://www.freel2.com/forum/topic32504.html If you want to see what I did for my S80 3.2 then take a look at this link https://www.matthewsvolvosite.com/forums/viewtopic.php?f=31&t=87687 And you are corre...

ABSCATE If we are going to make that adjustment we will need to Reconcile: the Generally Accepted Accounting Practices vs the Allegedly Acceptable Recordkeeping Practices G.A.A.P. to A.A.R.P. reconciliation First we must confirm compliance to the Part 2 guidelines Note: due to restrictions here par...

One more link This one is from a guy in Dallas that shredded his belt just like you and he is back up and running now https://landroverforums.com/forum/lr2-35/2008-lr2-steering-pump-replacement-complete-tutorial-extensive-93453/ I call the devoted 3.2 owner that help each other out FRIENDS OF PAUL H...

For my LR2 I purchased programmed Continental sensors The equivalent for my S80 would be (this is what I will buy when needed) VDO / CONTINENTAL SE10004A 433.92 MHz; Multi-Application Sensor; Programmed Make sure that you get a programmed sensor. I did change the Wheels for my S80 but I just swapped...

If the pulley in the picture is working it will spin easily in one direction and not at all in the other direction.

You are correct it is gear driven but it should freewheel like a bicycle

Good luck

Paul

Result!!!!! Well Done As for the Thermostat most of the parts are the same for the S80 LR2 and XC90 The exception being the small hose in the middle of the manifold at the top Take a look at this link https://www.freel2.com/forum/topic32245.html ( Edit: Broken link repaired ) You may be able to do t...

Matt,

Here is a table of typical torque value for a Bolt into steel dry or with anti seize and also for Aluminum.

I believe that this is for a Grade 8 bolt.

Thanks

Paul

MVS Readers, I bought my S80 a Christmas gift (actually it will work for all of my vehicles but don't tell the S80) Autel 539B Diagnostic tool AL539B.jpg This tool has a lot of capability I purchase it because of the Mode $06 data, and I don't currently have any tool that will show me this data. He...

Pending code P2227 - barometric pressure sensor intake manifold I need to disclose something; I broke the latch for the connector on my MAP sensor about a year ago and I did what I would call a field expedient repair. I RTV the connector body to the MAP sensor. And this worked for about a year. I d...

I have a P3 not a P2 but I broke my Radiator when I tried to replace my Prem Air sensor Search for Close up of the Prem Air sensor on this page https://www.matthewsvolvosite.com/forums/viewtopic.php?f=31&t=87687&start=40 The Sensor on mine is attached to the Radiator on the Fan side. If you ...