Just read through this entire thread (I'm at the beach on vacation) as I'm getting ready to do this on my son's '07 S60 when I get back to town. There were some misconceptions in the thread by a few people that need to be cleared up although the posts/questions were years ago. First off, we do a dra...

Update: three days of hard driving and washboard gravel roads and highway driving totalling 1200 kms and all’s well! No vibration, leaks or strange noises. I tried to put the welded sleeve through it’s paces to ensure it wouldn’t fail and it held solid. I feel with this setup that there should be no...

I'm pretty sure one of the Grom options gives you the ability to do MP3s, but there are some limitations due to it using the CD changer controls, IIRC only six folders or some such. Here are the links to the three main the pieces I ordered: Headunit - https://www.amazon.com/gp/product/B07WXNZSQT/ref...

I picked up some OEM struts for $100 for all four, someone had bought them for his 4C car and had them on for a week and decided to get the correct ones, I then purchased new Lesjofors standard springs for the front and rear and installed them today. There seemed to be a bit of difficulty from some ...

It's 50 ˚F here today! The long bolt with red loctite residue is a factory drive shaft bolt - those go in the flange from the front. On the short bolt that you can use from the back of the flange for driveshaft removal, I think its 12 mm long, you can see the threads are mashed in from using it to d...

Thanks! This should be an interesting trial, then - I've got a Dorman in the back and...whatever CO driveshaft sells in the front. I'll ask them who the manufacturer is , since I didn't see any indications on the box. Both seemed decent. ....... Colorado Driveshafts told me they're made in Turkey b...

I replaced my fuel pump yesterday and used this tool to do it. Your design works. I field tested it for you. I printed in PETG 0.6mm nozzle at 0.32mm layers and 100% infill. Total print time was about 7 hours. 43 meters and 129g of Total material used at an estimated cost of $3.22 for this particula...