Sorry I did not Proof read the last post anyway, I am encountering a “linking error” while trying to connect my maxi link ML619 Scan tool. I noticed while it was trying to boot up that it paused on KWP 2000 and the ISO 91 41-2Protocol for a little longer than usual I have used this tool on this car ...

Trying to get everything back together with this new UEM. I am in countering a leaking error when trying to I hook up my I’ll tell Maxi link ML 619, I noticed when it is trying to link up it pauses longer than usual on the KWP 2000 and the ISO 91 41–2 I don’t know if that has anything to do with any...

Is there a way to reset the alarm/siren, my fob won’t do it, battery disconnect won’t do it, Lock and unlock three times won’t do it.Don’t Forget that my UEM is out for reprogramming, i couldn’t get it to turn off before either.

thanks for your reply; I figured out that my upper control module (uem) the resistor was bad I found a good one with the same numbers and I sent it out yesterday to get it reprogrammed and I should have it back Monday most likely. I checked every wire in my "slow speed" Can network and I h...

I am getting "linking error" with my obd2 scanner (Autel Maxi Link) that I've used before and it worked like a champ

07 S60 2.5t 112k I had the airbag service urgent,dim,Central locking, no sunroof,Pwr windows,locks,int light etc... problems! Repl CEM (xemodex) I had to remove entire dash to repair a couple of ground and miscellaneous wires (solder) I’ve been through the entire system from front to back but still ...