Did talk to Volvo they could try reprogram srs module for approx 120usd, will try that before i play more

Thanks

Did connect with vida and got these errors:
2 pending and 1 static

Pending:
SRS-0026 Passenger airbag, stage 1. Configuration fault. Permanent fault
SRS-002E Passenger airbag, stage 2. Configuration fault. Permanent fault

Possible source
◾ If the SRS
control module
identifies that
an airbag or a ...

I have a v70
I had 16srs errors i could read them but not clear fault codes

Did remove battery and replaced SRS module, found a used replacement from same car and matching hardware and config id.

After replacement i could reset dtc codes, and did have 3 codes left

SRS-00DB
SRS-0034
SRS-00D0 ...

Hello!

Do anyone know if there is some sensor on manual gearboxes that register neutral gear.

Or if there is some sensor on clutch pedal.

Doing some testing and need to get 2 signals at same time.

1)
Brake + clutch

2)
Neutral + break

3)
Neutral + clutch

Some of above combinations

Thanks that helps alot :)

My main problem is that when i run car it hold programmed vmax speed, but if turning key fast from post 2 to betwean pos 1 and 2 and back to post 2, car rushes and goes above programmed vmax, every time i make that thing with the key cars gains 4kmh above programmed vmax ...

50 is starter
15 i think is can perhaps, i gues if i check cable and its twined if its can, should go to cem if i understand correct, but can a can cable be switched on off ? Should it not be a pair going to next module

But have no clue about x and 151

Hello!

Im trying to figure out the signals in the key lock but strugling in the v70 schematics file.

I found key part and only found this, but dont know what signals is on the pins. I can see some goes to cem but dont know what signals it is. Like ecm, radio, light?

Pos 3, adds signal to 50, and ...

Started playing with a gui for: https://github.com/vtl/volvo-cem-cracker

https://github.com/3Wings/Volvo-CEM-Gui
Its not working at the moment, its just a start, will try to fix so pin will be displayed in app later, at the moment it just a ide of a gui.
much work left before i could be used.

best ...