Because one never knows when the urge to bake will strike…

I noticed a discussion or two about the tool to install the clamps. I didn’t see any pictures, but this is what I have and there’s a special technique to releasing the clamps. It’s very easy. I think you could see it on YouTube.

Has anyone made a positive ID??

Nelly?
OJ Simpson?
I can’t tell

I have a front and rear swaybars for S, V, 60, 70 & 80 FRONT WHEEL DRIVE ONLY. Brand spankin new, never installed but missing a couple o parts like bushing brackets and bolts and end links? If I didn’t mention it. THESE ARE THE BLUE IPD SWAY BARS.. I believe the front anti-swaybar is 25 mm and the ...

Will check that out


Mine is the VDO cluster so I do not know if it was also done on the YAZAKI clusters.
The first time I saw it, I was shocked. I didn’t know what was going on. Somebody was joking with me. I never thought that a manufacturer would do something like that. I think it proves ...

Hy Guys,

I've replaced the all fuel lines last winter. Unfortunaltly, hoses seems to be as bad quality. I need to rebuild the all thing.
Which size of hose shall i use for inside :
A mm and outside B mm ?

Manov


I’m pretty sure 6mm is the common FUEL LINE ID and if not, it shouldn’t be ...

It sounds like you are trying to measure the resistance in the wiring harness and verify the harness itself is OK. One way to do that is to measure each wire one at a time in the harness from the pins inside the CPS sensor connector back to the ECU to make sure each wire individually is low ...

[attachment=0]IMG_1122.jpeg[/attachment

The Volvo 850 1995 troublshooting guide states 200-500 Ohms for the CPS:
"ENGINE SENSORS & SWITCHES
CAUTION: To prevent damage to Electronic Control Unit (ECU), ensure ignition switch is in OFF position before disconnecting or connecting ECU.
Crankshaft ...

Don’t tell me I’m the only one that noticed this. Look closely and on the inside of your instrument cluster, it will have, solder moose on the board. Fascinating.

manovlov wrote: 28 Aug 2026, 21:23 Hy Guys,

I've replaced the all fuel lines last winter. Unfortunaltly, hoses seems to be as bad quality. I need to rebuild the all thing.
Which size of hose shall i use for inside :

• A mm and outside B mm ?

Manov

Make sure it is rated for fuel injection