I'm able to simulate the tape under tension by opening the tape & re-routing the tape inside the cassette. I have an SC-815 deck that doesn't have an Rch and Lch pass through hole on the PCB. I found this tip, http://www.atthetipwebs.com/technologyinstructions/volvo_stereo_mod.htm, where I ended ...

Somewhere along the tape path, there will be a cam that detects the presence of tape under tension. If it doesn't get any, it assumes the tape is being eaten, and ejects it. Look for the cam and either simulate its being held under tension, or short its contact switch.


Has anyone figure out how ...

I replaced a pair of rear coil springs and rear shocks on my 850 wagon yesterday. Is it required that I have the rear wheel alignment done?

#b2fkb0 - Will a non-grounded 3.5MM stereo cable do?

#Doug M - Where did you buy the S70 wiper arm?

Does it matter what year the S70 wiper arm comes from?

Which surfaces do you paint: both inside & outside surfaces that mate w/ the hub & inside of the wheels? or including the inside/outside cylindrical surfaces?

Red-Arrow wrote:+2 on paint or spraying the. I put mines on without paint only to remove them a week later. I had to buff down the rust and paint the sucker. It still looks mint 1 month later.

Would any spray paint (i.e., krylon) do that sticks on steel?

Bad spring seat . . . Does this need to be replaced or repair immediately?

Nut is able to spin on the passenger side. So is the spring seat or strut mount that needs to be replaced?