I have a 2009 S60 with halogen bulbs. My daughter had an altercation with a pole requiring replacement on at least 1 assembly. I found a set of older halogen glass assemblies from 2001-2004 from back when they had the wipers. Anyone know if these older assemblies fit up the same way as the 2005-2009 ...

Thank you for the comments & help.
I finally have solved this after replacing the bearing. The best I can tell is that in the process of removing the old bearing the first time. The seal that jimmy57 mentioned must have become dislodged. Being that it was 17 years old, it took some persuasion get ...

Thanks for the advice. Well, this is a FWD car, and since there are no axels in the rear, the mechanism that the sensor reads from is buried in the bearing, so no way to check it that I’m aware of. If you read earlier in the post, I had replaced the bearing just before the sensor stopped working. I ...

Following up on my abs sensor adventure. I did find a sensor that “works” but was reading wheel speed erratically…going down the road it would jump back and forth from 0 to random speed values. Pulled the working sensor from my other daughter’s 2008 s60 and swapped it with the 2009 S60’s sensor and ...

Finally was able to get under the car, and the good news is, on FWD cars, the bolts are easily accessible….an open gap right next to the axle.
The bad news is none were loose, so still on the hunt for the evasive, intermittent rattle I’ve been chasing.

Yeah, I would if it were available to me. Just trying to be ready next time my daughter brings it home.

vtl, the vehicle is FWD, so no angle gear. Can I access the port without axle removal?

Thanks so much. I have a new project on the list!

I appreciate the advice. I didn’t realize they could be so picky. I made some progress since my last post…I have 2 s60’s (2008&2009, One for each daughter!) Not sure why I didn’t think of this sooner, but I took the sensor from the 2008 & installed it in the 2009. It worked, so, I know it’s the ...

I have a similar sound on my 2009 S60. Where exactly are the “bolts between the flywheel and torque converter” located? A picture would be enormous help.