I finally have gotten the module p/n 0 285 001 042 (says 01) I'm assuming (there I go again), 1 air bag no pass bag,

Will a 0-285-001-040 (says 02) out of a 94 940 work since your only using 1 air bag.

Just for info, 1 person in vehicle, blew drivers airbag on impact (driver ok), minor damage to ...

My sons done it again, blew the air bag, (fell asleep),he is ok, 2nd time, found a doner, have to swap air bag, clock spring and drivers seat belt, there was no passenger in vehicle.
3 questions:
Does the control module have to be replaced or can it be reset?
Will the pass seat belt have to be ...

I have a 93 940 Automatic,with 200k+miles with no ck engine light, and it runs great, took for EMI today and the inspector said that he was unable to maintain 25mph on the dyno for the ASM acceleration simulation mode test in the state of Georgia, Any Ideas? Thanks, Rick

Thanks Bill,

Pulled codes it was as suspected, 232, the LH seat belt, Followed your directions to a T, and reset the light, 12 drive cycles and 60 miles all is great, no light,

Thanks again for help and assistance,

Rick

Thanks Bill,

You hit the nail on the head. It was a bad TPS, tested it and the circuit as suggested, replaced TPS and set up as you suggested and it works great. It can be done by only removing the cruise vac diaphragm and it's bracket rather than the throttle body and hoses. (as my throttle body ...

I had replaced the drivers air bag, rt seat belt pretension er, ACM Airbag control module, but not the left seat belt pretension er after a previous wreck, the SRS light came on, naturally , I have now replaced the left tension er , can I reset the light and activate the system or does it require a ...

I have 1993 940 non turbo with around 200 k (it was involved in a bad accident, totaled and rebuilt, son ok) t boned left front wheel straightened out, alignment good, runs great looks great. Son's college car. Idles ok 900 for 5 sec then goes to 1700 as a base idle NO CODES ( it does this started ...