I have a 2003 V40 and the brake booster switch just flew apart and I cannot find pn 30620958 ANYWHERE. Does anyone have a used one or know of a later pn that I could adapt to my car?

Thank you,
Richard

I have a 2003 V 40 turbo wagon with 136K well maintained miles. Recently an elusive oil leak has shown up on the engine side facing the firewall and dripping off of the pan around the center of the car. Under the car it seems to be coming from up top (not the pan gasket) but close inspection from th...

Was working intermittently and erratically, then stopped working completely.

Hi Rick, Thanks for checking. I did not change it out right away (waited for the 2N3055 to fail) and it's been in for about 6 months now - so far, so good. Going into summer and the AC will get a workout so we will see. I have noticed the fan speed modulates quite a bit with this resistor, where the...

Many thanks for all the input. It was any or all of the following: a bad strut bearing, strut, sway bar bushing, sway bar link. We replaced them all, both sides. $1300 usd later no more rattle.
At least it wasn't the airbag...

Alschnertz, just so you know I took your advice seriously, I changed out the sway bar links - no change in the rattle. Any other rabbets in the hat?

Thanks. I'm assuming anything is possible. However, I have had the right wheel off and closely inspected the whole suspension without finding anything. This sounds like it is inside the car at the area higher up where the glove box door meets the dash and just behind the metal shroud. However I have...

We have a 2003 V40 Wagon in pampered condition, 103K miles. Suddenly, and about 3 months ago, it developed a loud rattle that seems to be coming from behind the metal glove compartment shroud. It sounds like a suspended hard surface like a plastic wire connector vibrating and hitting against a metal...

Rick to the rescue again! Thank you.

Found in the engine compartment of my 2003 V 40 wagon. It was sitting near the cover and near the fuel pressure regulator. It is also very clean, and was without a fastener. I cant figure out where it goes. Help anyone? Pics here.
http://artandframecopywriter.com/volvo