Thanks again Jbeebo .. I will post some pictures once I am up and running.

ATB

Wade

Thank you Matthew .. you have a great community here!! And yes Jbbebo and Abscate are awesome!

Now I need to build a new base to attach it to my simrig as none of the the attachment points match up (of course). It may be another week or so but I will post a picture once its all up and running ...

Success!!! Thank you jbeebo and abscate for taking time to help out with my odd request! I just soldered the ground to terminal 2 on one the switches and it works like a dream. I was able to use cut the two prong plug with B/R and B to wire to my battery.

Thanks again guys!

Update .. Not sure how I missed it but you are absolutely correct the upper right contact relay does indeed trace to the negative pins. Here is the updated picture:

jbeebo ... I mentioned in a previous post that 2,3,5,6 are all connected. Although I can not seem to trace any of them back to black. I've updated your most recent board layout to depict what I was able to probe.

With the latest picture do you think I should next try to splice or solder my power ...

jbeebo ... you are correct that the relay connections are indeed connected .. however neither appear to be connected the SW2 traces that you depicted .. thanks again for all the help!

I just did some more probing around and found that all of the grounds also go to the middle pins on each of the switches .. so in the example above 2,3,5,6 are all connected.

Guys .. thanks again for helping out .. I was finally able to check the G/R traces. Below is what I found out. The black circles depict were there was no connection on the trace. The trace from G/R was to only one side of the switch. I was not able to and of the traces to the Black. I hope this ...

Thanks again for all the effort! I just want to make sure I understand .. Do you want me to get +12V to the G/R and Ground to B on the connector end or on the board itself. I am good with using the multimeter but not sure where to start on getting the 12v and ground to the board/motors ...

Thanks again abscate for taking the time to help me out. I am showing how little I understand about the wiring logic!! The only blue red and black wires I see are in the picture below. Should I be wiring to the 2-prong plug? And then to bypass the stop logic run a blue red connection to one of the ...