Today I removed the tire again and I put a jack under the spindle and when I jacked it up, I noticed the top of the end link would move up and when I lowered it it would drop. I tightened it and the noise is now gone. I tugged on the previously and they were right. I do have a new cv axle on the way ...

It doesn't appear that the boot is ripped but there is quite a bit of play in the inner joint when the wheel is on and the car is on the ground. I have not replaced the front and back pneumatic mounts as they don't look bad. Yes I disassembled the McPherson strut and replaced the rubber seat. The ...

A few days ago I started getting a rattle clanking noise in the front drivers area. It is most noticeable when im going around 20-25 on bumpy roads. Today I jacked it all up and replaced the lower passenger motor mount since it was the last mount that i needed to replace and the sound is still there ...

So today I replaced the lower left ball point, it took around 35 minutes from start to finish and so far the clunk has not returned. The old ball joint was a lot worse off then I thought. A few tips for the who have never done it. Remove the steering spindle instead of trying to do it on the car, It ...

Thanks for the info Pete. My steering has felt a little weird when I am going slow in a parking lot and making sharp turns. There is definitely something wrong. I will check the CV joint where it goes into the transmission. I am wondering if it came out when I replaced the spring seat and sway bar ...

So after chasing the drivers side clunk for a while, this morning I jacked up the car both sides and removed the tires. There are a few things that looked out of place that I have questions about that maybe someone can answer. #1 The CV joint axle shaft on the drivers side, the inner joint has a ...

I dont hear it all all when im driving, only the first foot of movement from a stop and not always but most of the time.

I have around 174k miles. I haven't replaced the passenger side mount because it sounds like it is the drivers side. What am I looking for when I pry the ball joint? I assume that i am carefully applying pressure to the lower control arm to see if the ball joint separates? Could it be the large ...

I have been trying to find the cause of a front end clunk noise ( sounds like a rubber mallet hitting something) and I have run out of ideas. It only does it when i go from a stopped position and not every time. It sounds like it is coming from under the drivers floorboard, tire or tranny area. I ...

So after having ECM 9150 code and service engine system light, I went ahead and did the contactless TPS refit. That code went away and now it seems like there are more issues.

Does anyone have any recommendations on where to start with ECM- 917F and ECM-959F? The car will also limit to 4K rpm? I ...