problems after transmission replacement!

jbrown122 · Post by **jbrown122** » 22 Oct 2010, 20:21

We just had a used tranny put into our 2000 S80.
The used transmission shifts fine, but under acceleration, it makes a whining noise.
I also noticed when starting, the tach bounces up and down and takes a bit longer to start (crank sensor?)-CEL is back on as well.

When replacing the tranny, the starter broke, so there is a new starter in.

Is the starter and crank sensor problem related?

Will the noise in the transmission go away, and is it harming anything?

Thanks.

balah26 · Post by **balah26** » 13 Nov 2010, 11:37

check your flywheel for starting problem, bcos once there is a dent or crack no matter how small it is the starting would be fluctuating. have the same problem too after changing my transmission my car can not start untill i try for about 3 to 5 times b4 it start.

balah26 · Post by **balah26** » 13 Nov 2010, 11:41

check your flywheel for starting problem, bcos once there is a dent or crack no matter how small it is the starting would be fluctuating. have the same problem too after changing my transmission my car can not start untill i try for about 3 to 5 times b4 it start.