So I am stuck on my install and I need some help. I really dislike vacuum/air lines and I think every car could do without. Almost all of my questions involve small lines.
In picture 1 I have two lines coming in from a hard line near the bottom of the engine. There is a little control module then the single line with two separate connections, I marked them in red. Where do they go?
Picture 2: What connects to that nipple, it's on the inside of the throttle body/intake manifold.
Picture 3: This line is just plain confusing. The red sections appears to connect to the rubber nipple that the arrow is pointing to, correct? Does the other end (orange) go to the PCV box under the intake? And the blue circled line goes to the arrow and then where to on the other end?
Picture 4: This big ass line connects to the intercooler and ends under the intake, where to from there (blue)? I can't believe I can't figure it out, wherever it goes it is big! Also where does the small vacuum line go (red)
Picture 5: Where does this small nipple go? I vaguely remember it having a hard plastic line but it was almost two years ago when I stripped it down so I can't remember everything.
Finally on picture 6: Where do the three lines go? I'm guessing the one with the big protected end hits that small pip above the turbos?
I dont have a picture of it but where does the large brass colored nipple go that is under the turbo pipe in the intake manifold. It's the largest one on the manifold and sort of points up at an angle.
Thanks so much for any help. This was an easy install up until now and I don't want to route anything wrong and chance screwing something up. I know it will take awhile to educate me and your time is IMMENSELY appreciated.
