ECM-990F torque monitoring faulty signal

Delirious · Post by **Delirious** » 02 May 2012, 18:39

Need help please,
I checked the net for this but came up empty what is it and where is the problem component.

Post by **jimmy57** » 02 May 2012, 19:02

which vehicle which engine?
I think it is the S60 but the engine isn't specified and I would guess that it is a 2.4 non turbo.

Delirious · Post by **Delirious** » 02 May 2012, 19:44

jimmy57 wrote:which vehicle which engine?
I think it is the S60 but the engine isn't specified and I would guess that it is a 2.4 non turbo.

S60 2.4 non turbo

Post by **jimmy57** » 02 May 2012, 21:59

Did it have an episode of low power or run out of fuel?
That code means the torque output of engine and the throttle opening, fueling, cam timing, and ignition advance all were not in line with the crankshaft acceleration.
If the car had an episode of low power for some reason then clear the code and keep driving.

Delirious · Post by **Delirious** » 02 May 2012, 22:27

jimmy57 wrote:Did it have an episode of low power or run out of fuel?
That code means the torque output of engine and the throttle opening, fueling, cam timing, and ignition advance all were not in line with the crankshaft acceleration.
If the car had an episode of low power for some reason then clear the code and keep driving.

Did not notice any driving issues, have not run out of fuel either but I do have another code ECM-640A (P0011). I think that is the CVVT solenoid gone bad?

Post by **jimmy57** » 02 May 2012, 22:54

OK, that could make the torque code show up.

Delirious · Post by **Delirious** » 28 Feb 2013, 07:36

Still getting the error, and it is the only code I have. Is it a transmission ECM?
Anyone?

Delirious · Post by **Delirious** » 01 Apr 2013, 20:12

jimmy57 wrote:..............That code means the torque output of engine and the throttle opening, fueling, cam timing, and ignition advance all were not in line with the crankshaft acceleration.
..........................

Just a thought here.
Could an incorrectly installed timing belt cause this? like off a bit (there is no other fault codes)

jda2000 · Post by **jda2000** » 05 Apr 2013, 12:31

yes, the 03 S60 has an exhaust CVVT gear, and if the t-belt is off one tooth it can trigger the code.

Did you recently replace the t-belt?

Delirious · Post by **Delirious** » 05 Apr 2013, 18:28

Not recently, but this code could have been there without me knowing as there is no engine light to indicate this particular issue. I will check into this when it warmes up outside.