Login Register

1999 V70XC Homemade smoke tester

This topic is in the MVS Volvo Repair Database » DIY Smoke Tester Tool
Post Reply
aquamann71
Posts: 11
Joined: 16 Feb 2014, 17:48
Year and Model: 1999 v70xc
Location: Nova Scotia, Canada

Post by aquamann71 »

I made my smoke tester out of a plastic bucket that has a rubber o-ring inside the cover. I got it from the grocery store. It had pickled meat in it but any bucket with a gasket in the lid will work. I drilled two 2 inch holes in the lid. I used 4 quick connects that are used on pneumatic tools, 2 male thread and 2 female thread. Applied a bit of Teflon tape to the male ends first and screwed them down tight.

On one of the fittings i connected a 5 foot piece of clear tubing with a plastic fitting that comes with tire pumps used to fill air mattresses. On the inside of the same fitting i put a 2 inch piece of clear tubing. In the short piece of tubing I stuck a Colt cigar( I nipped off a bit of the filter so it would fit inside the bucket) and lit it with a blowtorch. I snapped the lid on tight and used my aid compressor to blow a small amount of pressure into the other fitting, making the cigar smoke backwards, blowing a steady stream of smoke out through the air mattress filling nozzle.

Turn your regulator on your compressor down to a bare minimum. I could stop the air flow by putting my finger over the air fill nozzle. From there I connected to the evap line up by the radiator and had someone blow shot puffs into it as I followed the line all the way back to the gas tank. I found a leak at the j-hose and at the line on the filler neck that allows air into the charcoal canister. I had a crack in the j-hose and the purge valve was stuck in the open position allowing gas to evaporate through the 2 spots even when the car sat over night. After fixing both things I smoke tested again and everything was tight and the top of the bucket swelled a bit from pressure and some leaked out around the lid of the bucket which was good because you should only be using low pressure anyway.

It worked so well I geared up a large rubber plug that fits in the filler neck and used this to test the gas tank for leaks. Found one at one of the sending units. I got about 2 minutes of burn time out of each cigar, which was plenty long enough to find the leaks. I hope you find this as useful as I did. And all for under ten bucks! Happy hunting.
Last edited by matthew1 on 12 Apr 2014, 16:55, edited 2 times in total.
Reason: added line breaks

januwan
Posts: 208
Joined: 23 May 2006, 22:32
Year and Model: 97 850 NA 209 K
Location: SF Bay Area
Has thanked: 7 times
Been thanked: 3 times

Post by januwan »

Could you attach few pictures. I would be interested.
januwan

chrillew
Posts: 79
Joined: 27 Oct 2013, 07:04
Year and Model: volvo 850 T-5R 1995
Location: Sverige
Been thanked: 2 times

Post by chrillew »

Yea pictures would be great! Video aswell

User avatar
matthew1
Site Admin
Posts: 14801
Joined: 14 Sep 2002, 11:03
Year and Model: 850 T5, 1997
Location: Denver, Colorado, US
Has thanked: 2856 times
Been thanked: 1332 times
Contact:

Post by matthew1 »

Entered into the Volvo Repair Database.
Help keep MVS on the web -> click sponsors' links here on MVS when you buy from them.

Also -> Amazon link
. Click that when you go to buy something on Amazon and MVS gets a cut!

1998 V70, no dash lights on

1997 850 T5 [gone] w/ MSD ignition coil, Hallman manual boost controller, injectors, R bumper, OMP strut brace

2004 V70 R [gone]

How to Thank someone for their post

Image

Post Reply
  • Similar Topics
    Replies
    Views
    Last post