94 850 clutch master with later hose

skloon · Post by **skloon** » 17 Oct 2015, 15:26

I was trying to bleed the clutch master on my RN/manual swap, I have an 850 master but the clutch hose out of an 04 s60 to match the slave, it is leaking like a sieve at the master end and before I tear everything apart I wonder if it is the hose end on the one I have, I am going to go to picknpull to try and find an 850 hose but I don't think it will fit the slave end

Post by **Ozark Lee** » 17 Oct 2015, 18:54

You might need to cut and splice the hoses to wind up with the correct fitting on both ends (S60 to the slave and 850 to the master). There really isn't much pressure on it so you could do it with a tube and a couple of hose clamps.

...Lee

skloon · Post by **skloon** » 17 Oct 2015, 20:05

is there a difference with the master fitting ? it fit okay but once I put the pressure bleeder on it leaked horribly, of course it is in the worst place to access of anything

Post by **Ozark Lee** » 17 Oct 2015, 21:09

I have no idea if they are the same or not. I've never worked on a S60 and the only end I have hands-on experience with for the 850 was the slave end and it was an external slave cylinder. As I recall that was just a fairly standard flare fitting.

...Lee