High beams switch or relay

[mdpminc]

Trying to get to the bottom of this.
High beams stopped working and No it is not the light switch being in 0 position.
I did notice that when car starts driver side beam moved slightly up and down. Pulled the passenger side light motor, replaced with a known working one. OK they both do the same thing upon starting, home to set position I assume.
High beam stalk at the column has 3 position, first click is to flash, second is to keep highs ON.
Well nothing happens, will not flash nor will stay on high beam. No high beam indicator light present either..
I don't thing this would be a relay issue as the beams do reset (move up/down) for set position.
Could this be a switch module (31268566) or is this an ECU issue ?
Vida wasn't much help here, no error codes from ECU of any kinds.
Any suggestions please, otherwise it will be a trip to the dealer$$$$$hip

[zjevik]

You stalk can be malfunctioning. It is relatively easy to disassemble it and check if the contacts are broken.

Did you try to activate the high beams in Vida? This would tell you if your issue is somewhere in electronics or it is a hardware problem.

[chrism]

Did you check the fuses. As I recall there are separate ones for high beam and dipped (low) beam.