P80 P2 late PCV banjo bolt tip 31325709

[abscate]

Remembered this from doing the 1999-on PCV

You put the banjo on the fitting, with the two copper washers, then you put a sacrificial orings on the bolt to hold it together. Once you get the banjo started, snip the oring and pull it off.

You can also snag the oring with a pick and pull it off until it breaks

I spent the same three hours figuring that out.

[abscate]

Bump to move over to the P2 Forum where it applies everywhere...

[Rattnalle]

Neat trick.

I fudged it by using some random washers from a drawer with dabs of grease on them to seal after I'd lost the proper ones once too many and couldn't find them again..

[abscate]

You can’t pick up copper sealing rings without a copper magnet, either.