i have a 2002 XC-70 and my inside door opening lever stopped working.
is there a trick to poping out the plastic holders without busting them.
thanks
mitchellbd
driver side inside door lever
-
mitchellbd
- Posts: 32
- Joined: 6 April 2007
- Year and Model:
- Location:
-
billofdurham
- MVS Moderator
- Posts: 6507
- Joined: 2 February 2006
- Year and Model: 855, 1995
- Location: Durham, England
- Been thanked: 5 times
VADIS goes to extreme lengths on this topic.
"Detach the side piece handle at the bottom edge. Use a weatherstrip tool."
That's it. It looks like you insert a blunt piece of plastic under the bottom edge and gently push up whilst easing it out.
Hope this helps.
Bill.
"Detach the side piece handle at the bottom edge. Use a weatherstrip tool."
That's it. It looks like you insert a blunt piece of plastic under the bottom edge and gently push up whilst easing it out.
Hope this helps.
Bill.
Work was good - retirement is better.
1996 850GLT 2.5 20v Estate Manual.
1995 Peugeot Boxer 2.5Tdi Autosleeper.
Previously:
1984 244DL, Manual, Beige.
1987 744GLE, Manual, Green.
1991 960 3.0 24v, Auto, Silver.
1994 940T Wentworth, Auto, Blue.
1996 850GLT 2.5 20v Estate Manual.
1995 Peugeot Boxer 2.5Tdi Autosleeper.
Previously:
1984 244DL, Manual, Beige.
1987 744GLE, Manual, Green.
1991 960 3.0 24v, Auto, Silver.
1994 940T Wentworth, Auto, Blue.
If it's like mine the plastic clips each have a center pin that you push which allows the prongs to release from the hole in the door. When my insde latch quit I took of the inner door panel and was able to reattach the linkage to the back of the handle. Took about 20 minutes total.
-
- Similar Topics
- Replies
- Views
- Last post