2001 s80t

[John Altieri]

How do i get at the front headligft to replace the 55 watt low beam blub

[vegasjetskier]

How do i get at the front headligft to replace the 55 watt low beam blub

pg96a.jpg (13.46 KiB) Viewed 672 times

Replacing high/low beam headlight bulbs

The headlight bulbs must be replaced from the engine compartment.


--------------------------------------------------------------------------------

CAUTION:
· Do not touch the glass on halogen bulbs with your fingers. Grease, oil or any other impurities can be carbonized onto the bulb and cause damage to the reflector.
· Be sure to use bulbs of the correct type and voltage.

pg96b.jpg (16.7 KiB) Viewed 672 times

To remove a defective bulb:

· Switch off the ignition.
· Open the hood.
· Remove the plastic cover over the bulb (1) by turning it counterclockwise.
· Remove the connector (2).
· Loosen the retaining spring (3) by first moving it to the right and then moving it down, out of the way.
· Pull out the defective bulb. Note the position of the guide lug on the base of the bulb (4).

pg96c.jpg (16.87 KiB) Viewed 672 times

To install a new bulb:

· Insert the new bulb, without touching the glass, with the guide lug upward (1). The bulb will only seat properly in this position.
· Move the retaining spring up and push it slightly to the left until it seats properly (2).
· Press the connector into place on the bulb (3).
· Reinstall the plastic cover and turn it clockwise until it is correctly in place (4). "TOP" must be upward.

NOTE: If the vertical aim of your headlights needs to be adjusted for any reason (e.g., towing a trailer for extended periods), this should be done by an authorized Volvo retailer.