2001 S80 timing belt tensioner

rogerd · Post by **rogerd** » 03 Dec 2007, 09:55

When I tighten the center bolt of the new mechanical tensioner, the adjustment tang will not stay "in the window"- it goes back to the relaxed position. The allen wrench hole is at about the 10:00 position, although I didn't hold it while tightening ther center bolt. What am I doing wrong?

Post by **billofdurham** » 03 Dec 2007, 11:37

Welcome to Matthew's Volvo Site.

I'm not sure if this is what you have done but this is from VADIS. Hope it is helpful.

Bill.

rogerd · Post by **rogerd** » 11 Dec 2007, 14:07

What does this message mean?

Post by **MadeInJapan** » 11 Dec 2007, 14:20

You have to hold it with the allen wrench as you tighten it. At least that' what I gather from reading the VADIS file.