What are the dimensions of Volvo's "blind rivets", part number 982 565 used for fender liner and similar trim pieces? Are they simply black 1/8" diameter, 3/8" depth aluminum pop rivets?

You have to remove the transmission and separate the bell housing from the rest of the transmission. It is internal to the transmission and not easily serviceable. But I am very puzzled why the Park is not engaging. Yes, Park not engaging is a mechanical link from the shift lever cable to the parki...

Hi all, like I said previously, I share with you my work on SBL for P1. With this software running on raspberry Pi and a dual CAN board I was able to dump (EEPROM and Flash) the CEM on High Speed and Low Speed CAN bus line and also the DIM on both on bench and in car. I was able to flash eeprom and ...

You look very complicated, I can directly use VIDA to crack the CEM PIN, Vida ++ shark I mean if the PIN exists in the VIDA database it would be nice to know! I went through each table in the database at least several times, unfortunately the PIN is not stored in the local database. I'm talking abo...

dikidera wrote: ↑28 Oct 2024, 04:20 How do you have Vida online subscription ? It's very difficult to get, requires independent operator status.

Depends on where you are. In US any individual pays $70 and it is his for 3 days.

dikidera wrote: ↑17 Nov 2024, 15:48 So my P2 MY2005 (facelift) is excluded?

My P2 MY2005 as well

I rebuild the ETM as it was creating several codes related to faulty ETM, and throwing it into limp mode. The engine had a rough idling and strange lambda sensor readings (reading extremely lean at idle, actually running super rich). After rebuild is it still creating error codes, and limp mode. EC...

I’d bet on the cowl under the passenger wiper. When I bought my 05 XC90 used I needed to seal up the cowl as I got some water leaks from there getting into the passenger footwell after going through the car wash. Should be easy to diagnose once you get in there.

abscate wrote: ↑01 Jan 2025, 07:44 Big electronics change in 2005 MY

The CANBUS was divided into two separate circuits , one low speed and one high speed.

All P2s have two separate CAN buses.

If you purchase a radiator with plastic necks, get one with metal rings inside the neck to prevent clamp crushing.
volvolugnut