Yes....that's official size from Volvo after many customer's complaints about bent rims because of 50 profile.

I replaced original water pump with SKF...7 years ago. Hydraulic tensioner....as long as it doesn't leak and if it's still hard to compress and doesn't leak while or after compressing...i would leave it alone. Mine still original at 400k km. I'll inspect it on the next timing belt replacement and if...

viper69 wrote: ↑08 May 2023, 06:07 ...I’ll call Crutch, I found their site confusing with all the subdivisions of HUs.

Last time i visited that site because of front door speakers for 850...site said 160mm diameter while actually it is 130mm...front and rear door.

Totally useless site for me.

'94 before facelift in '95 used 4 bolts wheels/hubs in EU... as far as i know.

Yours(U.S) market '94 had allready been facelifted but for late '94.
Ours(E.U) in '95...but it could vary for some markets...like passenger side airbag,for example.

MooseGangJP wrote: ↑16 Jul 2023, 09:43 Advice please.

Tell me which wires that need to be cut and spliced together?

Thanks in advance

Read this:

viewtopic.php?t=29489

There is a big chance that you only have a clutch gap issue.

Fully working!!!

Yes.

3.2 L.H Jetronic management should have only one...before cat. There are two different types...zirconia vs.titania. The ones which are for m4.4. cars doesn't work in Jetronic cars and vice versa. You should have EXACTLY the same o2 sensor which was originally fitted to your car...with EXACTLY the sa...

Those aftermarket replacements are all the same. I recently had ac evaporator job on my car and replacement evaporator(Nissens) was around 1cm smaller than original one,dryer(NRF) was shorter than original. Evaporator pipes were a bit off and i needed to carefully bend them in order to connect them ...