Ok guys,….there’s a saying that goes something like “If you’re getting resistance on something, one solution is to expand the picture”,…or scope, or something like that. Well,….mystery solved. I got really really into concentrating on where the oil was coming from on this last go around. I got every...

If it wasn't for MVS I wouldn't have found FCP back in the day, FCP is my go to vendor for all EDM vehicles. I was lost when I bought my S60. MVS has been a huge resource of knowledge, assistance, and I've even made some friends here. I also found FCPEuro here, and have used them for almost all of ...

Update on 2007 S60 2.5T with 115K miles replacing axles, seal and ball joint . This is important addemdum: by removing the bolts holding the struts, the job is 1000x easier! - If you watch the youtube video by A1Auto.com for axle replacement, the lady mechanic used a pry bar to pry the control arm d...

I talked with Robert earlier today about a parts search I had asked him about, and he mentioned he had some concerns about his wife Dianne's health; he had brought her to the VA hospital in Las Vegas (Robert is a Disabled Veteran; we chat about our challenges with the VA helathcare system.) He has j...

I think everyone here knows Robert Spinner through his dedication to Volvos and his vast array of DIY videos.

He needs our love right now. More to come.

Hi all, Longtime lurker with first post. I own a late-2009 XC90 purchased used in 2011. I love this car but it has been neglected and abused due to some health and family circumstances (more on that in another thread). I know this has been covered well elsewhere, but thought I'd relate my recent exp...

Hey, the names Dave, (aka Boris) I've just recently purchased my first Volvo, a 1967 122s Auto. I've been a long time fan of the Amazon as a family member had one when I was a kid. lots of memories getting hauled around in the back of the 123GT. Any way, I've got some basic mechanical knowledge but ...

matthew1 wrote: ↑22 Jun 2022, 20:06 My goodness, how did you know that, Nick?

I'm a car enthusiast. You've seen some of the cars I've owned.

Bearings showed up a day early so I changed them this afternoon and the noise is gone! Surprisingly the bearings felt fine when I spun them and were also tight. They'd been making noise since about December. It took about an hour and a half to change both sides, I took a shortcut and didn't remove t...

In 2019 my rear catalytic converter assembly rusted out and got very noisy. The braid around the flex pipes was very degraded, and the flex pipes themselves were in bad shape with small leaks. There were also a few leaks on the hard pipes downstream. One of the flex pipes: Flex.png Support bracket r...