I'm just the New Guy, nowhere near that!

I got my wagon yesterday as well! Thanks Matt, and thanks for these incredibly useful forums! He joins this random collection....

I ended up just removing the belt and realigning all my timing marks when I installed the new belt and everything runs great

This low budget shoot did not include miniature wheel chocks

Update: After much hassle, I finally got the bolt out with a 1/4 drive ratchet 10mm socket and secret blend of 11 herbs and spices to get the length just right.

Here are screenshots of the new Bosch injectors for my car as a example. Not sure all the particulars of your 4 cylinder so you will need to do some internet shopping. June

Hey Guys I replaced my serpentine belt a few weeks ago and I follow this tread: https://www.freel2.com/forum/topic33363.html I recomend you to read that tread. I also write there some advises with some photos We use a joint Swivel Socket Adapter with a long extension to remove one of the screws that...

Well, we kicked butt today Diagnosed a noisy power steering pump, defcon 3....monitor closely for changes in noise Part options RockAuto $60-125 with core FCP $190 with core PnP $30 Evaluated cooling group, hoses look old , defcon 4 Need timing belt job, now at 220k, last done 140k, so due up, defco...

- Purchased a case today for $24.99 at Costco Warehouse - Qty 2 - 5 Quarts 0-30W. It's on sale online @ $5 off a case so basically shipped free at Warehouse prices. Only complaint I've seen is mishandling causing leakage upon arrival. Will hope to do 4 oil changes next week. Stuff I have picked up o...

Hey Creekybird - I have a full set of NOS caps that I would part with. I'm not active on this forum (just registered today to post this) but have been on turbobricks for a long time and sell on ebay under this user name (100% positive, almost 800 transactions).

I finally got rid of all the codes. After slowly testing every sensor with my volt meter I noticed the cam sensor was a little off. I noticed the bosch OEM cam sensor's wire clip was cracking and seemed to be grounding out. I temporarily repaired it and made sure there were no other wires in that ar...