I thought you might enjoy this film. I was looking for the Promotional film for the first R that got me so excited in 94. Cars just got better and better every year up through the early 2000s. Now they just get more gimmicky... Even brands i thought would never give in like RR have. Recently I went ...

Can anyone here explain the science behind say the quick condensation cloud between shifts? The boiling point of a fluid is a function of Temperature and Pressure . You are seeing water in the air flash to a vapor when the pressure in the Intake Manifold goes low. Then back to a liquid when the pre...

Embedded images are back.

Editor working.

I checked out the 2009 XC70 T6 that was near me. ($6400 with 134k miles) It looks like it was in an accident and not yet repaired. the Right rear wheel is pushed in about an inch, the body is wrinckled in the area between the rear side window and the liftgate. So that one is not worth the buy-in for...

Bill, take a snap of the plate in the inside of the driver fender. This might be the sought after Cream Yellow colour code that will help you get your price and move theproduct !,

You seek color code 607 on that plate

607-xx

'07 "Lava Sand Metallic" with genuine Pacific NW pedigree. 84k miles. Tidy.

https://bringatrailer.com/listing/2007-volvo-xc70/

My aunt would have my uncle add the previous car's horns to the new car from the early 70s through the late 80s. Her last GM car a 85 Lesabre had like 12 horns across the front. I won't say why on here as it's offensive, but it was quite a sound! The first car to loose its horns was a 72 Electra 225...

I’m about to do a long trip with my 2002 Volvo S60 from Alberta to Ontario to pick up a 16’ fibreglass boat on a pretty heavy duty trailer. Total weight to tow is approx 2900lbs. The car currently has about 280,000km on the odo. The trip is planned on the last week of October and is a 6700km round t...

Well, I finally did the zip-tie shim. I only used two ties, as close to 180 degrees apart as possible. Compressor works fine now. My slight concern is that the gap is not quite as even all the way around as I would like. It's about .3mm in places, but a bit over .5mm on about 1/4 the diameter of the...