Always great to see these cars survive

I had this happen on a left front subframe bolt once it was 100% IMPOSSIBLE to extract. I used the best tools and equipment available. IT would not extract. It would not drill out. Could not break it apart. Tight spot.... sheared bolt would not move no way no how. My solution was that I had an Reall...

Just a tip that I found serves me well. I glued a small magnet into inside of the door area that keeps it gently closed so it would not fly open if the latch lock failed or even the gas attendant did not close the door properly.

Prayers and best wishes. Same as everyone on the forum wishes for you.

Way to go with your "kid". Must be good parenting since they don't come with a manual and you cant connect them to VIDA DICE to figure it out.. It ain't easy. Great job to both parents and kid!

I've used both brands. No issues.

May be worthwhile, if you can, to power wash the underside of car before doing the rack. You can expect lots of crud falling into your eyes if doing it at ground level and not on a full car lift. Messy and unpleasant job to do in a driveway. Good luck.

yep. right fluid, drain and fill.

Rx = Chicken soup and a shot of whiskey, every 3 hours and you should be all better. or not care.

Not sure where to start to resolve these codes. ABS warning light and Brake assist warning lights are lit on dashboard OBDII CODES Read AS FOLLOWS: BCM-C00201C ABS PUMP MOTOR CONTROL BCM-C004664 BRAKE PRESSURE SENSOR "A/B" Signal Plausibility Failure BCM-U042864 INVALID DATA RECEIVED FROM ...