I was finaly able to install this modification today. I had already done the throttle body mod for the early 850 N/A which was a noticeable improvement in throttle response. But I must say, the "Yitsbox" tied up the loose ends as far as the seemingly confused powerband I was dealing with. ...

Here is mine which seems to be available again. They were out of stock everywhere when I was looking for it, so I ended up paying more than a new one. http://www.ebay.com/itm/OBX-Front-Strut-Tower-Bar-Brace-93-97-Volvo-850-97-00-S70-V70-C70-Flat-Type-V2-/160956331899?pt=Motors_Car_Truck_Parts_Access...

I made this a couple weeks ago to read the ECC codes from the OBD II port on my '96 Turbo Wagon. It is documented in my ongoing thread (at this point) to determine my intermittent ECC failure, but I thought it could be mentioned in the tool section. I was going to do a simple momentary switch, LED a...

Finally settled on what I needed to do to my wagon to achieve the look I wanted. First I went from 225/35/17 tires to a set of 225/50/17. That filled in the wheel wells better. There is only the slightest rubbing at full lock. Next I tried out a few combinations of struts/springs. Chose some struts...

Busy Summer! I still love MVS. I simply have not been taking as many photos as I would like.