abscate wrote: ↑19 Feb 2024, 08:09 You can see the depressions as it is obviously feeling blue….

That's the cylinder head depression blues.

66990, wow... I hit 272000 miles today.

Hi everybody, I have a V70R MY2004 with a brick-style CEM (30657629). What I want is to crack the PIN and upload it to d5t5 so I can enjoy VDASH even more. What would be the right procedure here? As i understand, the only way to go with this CEM is to read it directly f.e. with an arduino nano usin...

Thanks for your reply vtl. So we're talking about a 6-byte long value, right? Is it really necessary to desolder the flash memory chip? My idea was to connect pins at the board-locations shown in T5Luke's post I mentioned previously It is 6 bytes in BCD . No need to desolder if you do what T5Luke d...

All your foam seals are disintegrated from age and heat. I was doing a full HVAC overhaul 2 or 3 years ago, had to replace all the seals. Your best shot is to buy 1/4"x1/2" foam tape, pull the vents and fix it. You'll be washing your hands for the next few days, trying to get rid of the ro...

02V70 wrote: ↑23 Mar 2024, 20:00 They were cracking and users of MVS said to replace them
viewtopic.php?p=629695

That's brake hoses =) Lines are made of stainless steel if I'm not mistaken.

I used just regular wrenches, but flare ones would be easier.

weitau wrote: ↑24 Mar 2024, 21:45 lol, you can be sure it's not going to happen again.
still, I'm confused why Volvo would do this? maybe useful in a marital conflict?

The vehicle detected New York City and found no gun in the cabin. For the passengers safety let itself locked with the engine running.

Blacklab467 wrote: ↑28 Mar 2024, 05:23 It’s a nice piece of lumber, I believe it’s red oak or something. I feel like I should be smoking a pipe while driving it now!

Only when playing ABBA on your cassette player!

cn90 wrote: ↑29 Mar 2024, 08:30 This is why I never vacuum.
Best is to use compressor set at 10 psi.
I modified an ATE cap for air compressor, the DIY is in forum.

I had these tiny bubbles through screw threads even using Motiv pressure bleeder. No problem with the brakes after such flush, by the way.

It's "camshaft adaptation". 0-4 is good, 4-8 - acceptable, 8 and more - possible interference. One tooth skipped is about 8 degrees.