Any brand name 2DIN + SWC adapter. Take the camera power from the reverse lights.

I have a Kenwood DDX + DIY adapter (https://github.com/vtl/volvo-kenwood or lately https://github.com/vtl/volvo-ddd). You can solder a similar adapter or buy a ready to use.

xHeart wrote: ↑10 Dec 2020, 12:42 [Same for the 2001 V70XC?

Yes. You can double check it in VIDA: ECM has the "Fuel pressure" parameter if PEM is present.

I had a head resurfaced at home as well. Was 0 mm W and 0.05 mm L in one spot only. Managed to have all zeroes. Finding a flat area of a 3/8" thick glass. You get the head as flat as the glass is. https://a.d-cd.net/uQAAAgG17-A-960.jpg Dykem steel blue (wasn't really needed) https://a.d-cd.net/...

Great job. The best Lathes have the bed hand lapped/scraped to get that final accuracy. Better than the machine can do. Machine is just way faster and close enough for engine heads. Yes. Having good tools does help. However I went low this time, the biggest investment was a $50 glass shelf ;) I act...

No pressure! The head is heavy enough, you just need to push and pull it, as horizontally as you can. Because of a fine grit and wet sanding it took a few hundreds of passes, but in return it gives you a precise control of how much material is removed. I stopped when I had a couple of cavities reduc...

Pete, there was ORE V70XC for 2002. I know a guy who drives 235/650. "In 2001, to mark their sponsorship of the just renamed Volvo Ocean Race, special Ocean Race editions of the V70 and V70 XC were announced. Released for model year 2002 the cars only came painted in a unique shade of blue. Sil...

Start the Teensy first, wait for "sending CEM into programming mode", then immediately power on the CEM. CEM on the bench needs to see the ff 86 message in the first 20 ms or so, otherwise it goes into standby mode.

Add it back and make it switched then?

You need to talk only to CEM, on a fastest bus. Thus one CAN-bus is used. The in-car cracking would need to silence everything else, so there's another CAN controller, but it is optional and only used to hush the modules on the slow speed CAN.

Nice! ;) Zener diode is for safety. As said elsewhere, I was rebuilding my blown engine. It is up and running now, but I need to pass a long overdue yearly inspection, for which the car should have no codes erased for last 100 or 200 miles (erasing codes zeroes emissions readiness). I'll try it in c...