Good find! I wish you luck on the repairs.

Neil.

I used some 3.5mm or 4mm silicone hose from Verocious motorsports.

https://www.verociousmotorsports.com/Sh ... y-the-foot

A 2010 Ford or Chevy will be pretty cheap to service and maintain as there are many more independents and chains that can do domestic stuff. However, they lack panache, verve, and élan of Volvos; documented by the lack of Oxford commas and semicolons in their respective Fora. Hi, So what's your poi...

Get a replacement torque mount as well. Yours isn't even worth reinstalling.

Lots of work. I would also check the injectors, we don't know if they are the reason for it, but it won't hurt and is sensible imo. Maybe someone offers cleaning, or you can get refurbished ones... You an also try to clean them by yourself, build something to actuate the injector and spry carb/inta...

Resistance is only useful marker for ABS sensors if it’s infinite.

A scanner revealing wheel speed will tell you if the sensor is behaving.

So I finally completed the job and fired up the car! It's running good as new, but it wasn't without a few incidents. It took me a lot longer than anticipated because I did a lot of things on top of the rebuild. Here's a picture just before putting the cam cover back on. The gasket material is appli...

At this point you can have an ABS module fault and one or more faults outside of the module. It comes with the age.

I tested twelve 96-98 abs modules last week, 5 of the 12 had codes showing faults outside of the module on whatever car they came from.

I went through the same thing, but with far more hiccups. I have the combined Catalytic convert/Exhaust Manifold, it's a chonky piece and couldn't fit behind the now installed head. Obviously I should've have put it in BEFORE the cylinder head. I then had to remove the driveshaft to get it from dow...

As it turns out, extreme axle restoration may be more difficult and less perfect than it seems: The carrier bearing I bought (Febi 9181693) has a rounded profile instead of the flat edge on my 1999 and 2000 axles. It fits into the carrier but the only points of contact will be a thin circumference i...