It’s more likely the block ports are plugged

I think the smallhard hose only vacuums the PCV box at idle speed, though. You have to fix it so worth a try.

Bart...be careful routing those hoses in that XC tank. It’s easyto kink them and then you gets really brutal intermittent fuel delivery problem

MAF to Turbo snorkel is a 1999-2000 only part

Chalk up another for the bastards...its a 1999-2000 only part 9445351

I have one in my parts stash.

Probably Phillips 76.... brand name over here We don’t brand bash over here but The Euro / Asia split is pretty clean. I haven’t owned anything Asian since 86, and the claims of reliability and such are funny , given that automakers share supply chain My neighbor who claims his Toy transmission was ...

rspi wrote: ↑21 Sep 2018, 09:37 Junkyard. NJ has a few.

Other than that, prevention is best. Replace the fluid ever few years.

It’s not helping with this crappy aftermarket stuff.

I had Fresh brake fluid on replacement in 2016 and both pistons seized solid.

I think the C70 series shares the wiring with the V70 series earlier generation called P80 It sounds like the clutch is pulling too much current - that is the only thing that has electrical load on the AC system. You probably have to replace the clutch as the wired part is under the pulley It is pos...

viper69 wrote: ↑21 Sep 2018, 11:56


Where can I find this thread on Stage Zero. I searched the forum, found numerous posts w/those words in it, but not thread started by someone.

The best thread goes way back to 2009 - from Matt himself

https://www.matthewsvolvosite.com/stage-0.html

My P2 release bearing self destructed and spat little ball bearings out into the transmission bell housing.

Minimum on this job is pressure plate. Clutch disc, release bearing and hydraulic cylinder

Thanks for replying. I took it out for a drive and noticed the coughing is gone. I’ll need to drive it a few times to be sure. What’s a coil? As for the other parts I’m not sure. I’d have to check my records. Rotor... as in brake rotors? When should one replace wires and distributor cap? More impor...

I find it a lot easier to put the belt on the water pump last..it’s larger radius and you are pushing the belt down, which is easier than pulling the small radius up to the tensioner