Using the engine as a reference point Front mount bolts to subframe near crankshaft pulley Right hand mount bolts to subframe Torque rod up top bolts to firewall and top of cam cover Left engine mount bolts to subframe Torque rod underneath bolts to subframe I think there is a pad on the subframe at...

A Dremel might run faster?

AC compressor clutch. Try cycling AC button when noise is prese[not to see \if it changes

YOur harmonic balancer or crankshaft pulley could be loose. You can usually track down a noise to wtin a cm or so using a hose as a stethoscope

The sound does remind me of my bad AC clutch

I had this whine in my T5 and then my kids told me it was Taylor Swift

Update SEP 2019 If you search the part number, you will find that the pin quality of the rebuilds basically is sub par. My S70 lockedup both calipersdue to corroded aftermarket pins, which are poor quality stainless steel One of the reasons the rebuilds are so cheap are the cheap pins. Save your OEM...

Definitely start with spline count. If that’s different your swap ends there

You might be able to see if the steering shaft is a common part on Volvo OEM , drilling down on the steering wheel section and comparing part numbers.

Then do the same for the airbag and connector

I completely forgot about the freewheeling pulley That came on in the 1999 models and the SERP belt route changes ( the alternator spins backwards relative to the rest of the cars this Forum) I have the splinedtool to remove the pulley, that sucker is on really tight and is a left hand thread. The h...

Been a joy to bring her back to life after being neglected for years before I got her. Luckily she was low miles at around 55,000. Now she has 63,000 and climbing. Wow, sounds like you found a gem there with that low mileage. Hopefully the timing belt was replaced for age. [/quote] We live on the e...

If it fires in ether, and the injectors are delivering fuel, the fuel delivery amount is wrong. I think you need an oscilloscope to confirm the injector pulse ( more accurately , how long the ECU isnpulling the injectors to ground An ECU swap is the Mossberg method if you can’t get a scope , but you...

What a great thread. I just found it this morning and spent most of it ignoring the kids while I caught up on The Herman Chronicles. Abscate, have you tried the Lesjöfors HD springs? I put them on the Silver Bullet (‘00 V70 n/a MT) and absolutely love them. When I return the engine bar, we should s...