I recently needed to replace a wheel bearing on an 08 volvo xc 70 wagon n had a hard time finding info on that car specifically so I wanted to help out any future people working on that issue w there car. There are no bolts holding your wheel bearing into the carrier it is a pressed in bearing/hub a...

Motul 4100 15w-50 sds have incredible numbers on paper...with pour point of -42 Celsius...which is the same like 5w grade oils. Screenshot_20190420-132157.png I'm also impatient to see how the engine will behave since i have ocassional blue smoke after the car idle a bit,because of worn valve stem s...

This should give you a clue. The Sunroof frame is part number 3509020. Applications: Volvo 850 2.3L 5 cylinder A/T FWD R Sedan 1997 Volvo 850 2.3L 5 cylinder A/T FWD R Wagon 1997 Volvo 850 2.3L 5 cylinder A/T FWD T-5 Sedan 1997 Volvo 850 2.3L 5 cylinder A/T FWD T-5 Wagon 1997 Volvo 850 2.3L 5 cylind...

This kind of sunroof swap has been done many times: all P80 are the same, sedan or wagon.

The exhaust flange matters for install yes, but you can just swap the current flange over from the old turbo to whatever new turbo you get.

So if you're not changing the downpipe, flange doesn't matter just grab a 15g.

Thank for your help;

1. OK, how do I get VIDA/DICE and what will this cost?

2. Also: It's P0605, NOT P0650

3. How do I thank people?

wooshuck wrote: ↑22 Apr 2019, 14:50 Thank for your help;

1. OK, how do I get VIDA/DICE and what will this cost?

2. Also: It's P0605, NOT P0650

3. How do I thank people?

1. DiCE ~ $80.00 on eBay. A better version of Vida can be found here.

2. Typo corrected above.

3. Thumbs up in the upper right corner of the post.

that is the compressor bypass line it goes over to the the intake manifold tree. It sends boost pressure over to open the CBV mechanically depending on the spring installed, 8 pounds of boost stock. its function is to vent boost if you suddenly see a cop during high boost but before the waste gate c...

The software versions can be identical but key information is stored on the CEM so without some degree of programming they can't be swapped out. Also if the VIN stored on the CEM doesn't match the VIN on the body/windscreen plate Volvo will not work on the car. For some people that's a blessing. Als...

Yes, we can clone this ECM. But, if serious, I do not think issue in ECM. For get more info, need to connect to car and read few parameters first. We can do it online.