Ours is fitted with SAS for naturally aspirated aka non-turbo. The air pump is situated under the battery tray, but accessible with air guide off.
It is idling closer to 1000RPM -- you can feel her anxiety.

We are in our 5th winter this year.

N/a with automatic transmission is idling close to 1000rpm when it's in "D".
Manual a bit less.

abscate wrote: ↑06 Nov 2017, 05:10 Going to try some Permatex epoxy muffler bandage and clamps and see how it looks

JB Weld the clamp over the defect. The muffler bandage will deteriorate over time. JB Weld and clamp is a permanent fix.

Hy,
I didn't think about searching on the forum... For that I will copy back the 850 hole manual ten times. This question has already been answered.

Here: viewtopic.php?t=10238

This post may be closed.

Manov

BlackBart wrote: ↑01 May 2019, 09:49 Thanks everyone -
I'll check on that when I change the small vac lines. Interesting to note there's no boost in neutral / no load. So you're not going to hear or see anything from underneath to find a leak.

Mr Abscate -

WCM? RWCM? Royal Wellesley College of Music?

^^This guy =)

I wonder if leaving the key in the antenna is related? Is that how the lock controller detects you leaving? IT was doing this before I went to the “ external antenna key mode” to use my non-programmed keys I tried it on my S40 by leaving one key in the ignition. With one key in the ignition, the ot...

On page 8 of this tutorial there are more spec's on o-rings for the p80 A/C system.

https://s3.amazonaws.com/images.matthewsvolvosite.com/vo ... torial.pdf

abscate wrote: ↑10 May 2019, 22:16 If the fangordses k

Covfefe?

- S

Update in case anyone had the same issue: Pulled off the SAS hose from the airbox and plugged the port. Currently just clamped off the SAS hose so it can't spit dust into the engine bay, although I may need to make it its own little intake when emissions testing comes around. I tried cleaning the MA...

Any quality anaerobic should do, I see no reasons why Permatex won't work How is the oil passage from the PCV box, I think is this one, it should be cleaned nicely. See on the corresponding hole on the block side too. It is perhaps good time to also replace the PCV (maybe once the pan is back, a qui...