From the manual: "Shows the approximate distance which can be driven on the fuel remaining in the tank, calculated on the basis of the average fuel consumption during the last 12 miles (20 km) driven and the amount of fuel remaining in the tank at the time of the reading." As far as why it...

If you want to take it one step further, a P2 with the third seat will often also have a lock cylinder installed in the tail gate. That will allow it to be manually unlocked from the outside. The trick is finding one at the scrapyard that still has a key. The keys are usually nowhere to be found. Id...

abscate wrote: ↑07 Nov 2020, 11:55 Someone headed to a yard please pick up that piece Rick is looking for and I’ll foot the bill for that one

BM dub ya 1198 harvested one at his LKQ. He knows where to send any bill,

I have recently replaced the seat skins and cushions on our v70. According to Vida you need to recalibrate the seat occupying sensor in the passenger seat if you remove the skins and or cushions.
I would try this first if you have access to Vida.

No need to drop the subframe.

Reposition the subframe back over the nipple, screw on the good side (place a jack to support SB), then drill it out through the bushing - bolt hole.

New LEFT HANDED drill bit may be best for this task.

Hy Buddies , Manov on line I have chosen to become a donor member of the site. My approach has nothing to do with ego. It's a question of balance. Here, Matthew struggles to maintain the site on his own, like a big one. With modesty and kindness.This activity is time-consuming, by wagonloads of whol...

To OP's initial question: No. 95 was the last year with EGR in the US market.

ARW is the SAS valve but I don't know what the acronym stands for.

Although a switch, I have referred to this as the "jack-in-the-box valve" in the past. Now you know why.

Just completed installing 4 subframe bushings and new spring seats with genuine Volvo parts. Its a pretty straightforward job for those contemplating it. I didn't document the spring seat install as it is a simple process. Subframe bushings should take 3 or 4 hours with hand tools, nothing special r...