In this video the funnel is 9/16" (14mm) outer and 3/8" (9mm) inner. The 9/16" outer is the very max would fit and need to toss the metal clip to slide inside the tube. Warm up the fluid in hot water, will flow much faster. You don't need a hot engine, so won't burn your hands https:/...

If the p/s res stays put on the two lower slides, it should be enough. The upper tab is more annoying that useful

That's well done maintenance

I don't seem to have that value listed in VIDA for my 01 S60... No PEM on 2001-2002 As for the engine stall, very scary. It happened on the highway and even once on the city highway with no way to pull safely. All stalls happened when the tank was low, in warm summer days, after having driven for 3...

That is very low miles. Did you drive or park on an incline ? Can't tell about the check engine light but I doubt it's a pump problem (but could be a loose cap tank indeed). The sender is only attached to the pump assembly, yet not sold separately. You may ask a garage to remove it and maybe check a...

Not all shocks are as soft. Cheaper will be harsher. Tire pressure does affect, anything over 35 psi will feel harsher depending on the road. Try a 32psi see if it helps. I have new genuine shocks, original springs, 15" wheels and new CA's. Roads just as bad as in NYC. Ride is a bit harsh for t...

Even if you don't have the sunroof, may also want to slide a hand under under the front pass carpet, careful because it tears quite easily. Leaks may come from the cabin blower, cabin air filter cover, AC drain, etc I would not recommend the following if you have exhaust leaks, or if the trunk batte...

Sounds like a tired vacuum pump. You may have a vacuum leak somewhere, one place to start is the 'switch' right in the center of the video with brown connector. On the switch, it says 'motor' on one side, make sure it's the hose that goes down towards the pump. If that's fine, may try replacing the ...

I dare share this with you even if it's not about a car, but still has an engine to it I had many troubles with a rather new snow blower when trying to start it after the summer storage. While there are a couple of things that help - such as draining a little bit of gas or even removing the emulsion...

Good job. Good point about not pushing directly on the rubber tabs. When pushing directly on the plastic with the 4 nuts, did the plastic lip feel solid enough ? I may add, the two smaller 14mm bolts on the rear bracket are 37 ft-lb torque Since other people will watch this thread in the future, I w...