Original bushings are glued to the bar. Yes, one need to weld something onto sway bar to limit lateral movement with greased PU bushings. Front sway bar job is unfortunately PIA on this car. Rear is PIA too, but slightly less. It is a bad idea to weld to springs. The metallurgy will be changed and ...

My opinion is the noises when turning is from the friction in the joint. Thread lube will reduce the friction between the bolt head and cylinder head and the bolt and block threads. This is good. The friction interferes with the proper torque. You could have used an extension pipe on the last tighte...

2012 S60, T5, about 129,000 miles. Brief History: Purchased a year ago off a questionable car lot.....for the teenage stepdaughter. CEL within a day after purchase, replaced the catalytic converter with aftermarket. (Probably why it was sold?) 3 months ago, the teenager got lazy and quit checking t...

I am no expert on these codes, but codes can cascade from minor to major Canbus problems. I would expect others to comment.
volvolugnut

If I stand up and clap will you do an encore?
volvolugnuty

I have an old Pentax SLR and a collection of used lenses. I used to take a lot of photos years ago, but have not taken any photos recently other than cell phone use. I also have an old Nikon SLR with a shutter problem. Unfortunately, there is no Matthews Nikon Site to tell me how to repair it. With ...

Use cardboard covered by garbage bag moisture barrier. Bag will be reusable, cardboard not so much.
volvolugnut

I have studied this photo a lot (it has been used a computer wall paper). The rocks on the left side look like remains of a mill - perhaps to grind grain. The small house may have been a small water powered electric plant. The photo was taken from a highway bridge with pedestrian walkway. Perhaps so...

Munchy is hilarious in the snow! "Why am I here where it is cold and wet?"
volvolugnut

Goals and things to look forward to are the stuff of living.
volvolugnut