You say you installed the locking tool in the notches at the rear of the cams to lock them at horizontal, correct? He said he installed it in the block, I think he speaking of a Crankshaft Alignment Pin not a Cam Lock. The way to verify a Crankshaft Alignment Pin is set correctly is to look at the ...

Find doublebug (Henry) on the board. See if he can reprogram / pair a new remote for you - you will need an OBD2 cable..

Question: When you press the key fob lock or unlock button, do you hear a clicking in the driver door? If so, it may be the grommet (plastic) holding the rod that unlocks/locks the door is busted (ie. the rod is disconnected). It could also be your door lock mechanism has gone bad...that can be tran...

Thanks for the great replies. I may not have stated what I wanted to do correctly. My wifes 02 XC70 has a problem with the locks. The key does not work in the door and the remotes dont work. If I could locate a junk car - with functioning keys, locks, ignition and remotes - could I transplant those...

normally i'd say from my experience to use the original switch if it worked and you should be ok...
Sounds like you tried that.
perhaps someone else can share their experience, I know this stuff drives me bonkers too !
Wade

Check that you haven’t crossed a CANBUS change in the P2 line.

Switches don’t control current anymore in P2s, they send signals to controllers to request action.

when you swapped out the all electronic canbus switches with your original switches, check the wires are the same sometimes they make small changes.

CANBUS - its the era of computer control of stuff vs the old school method of wiring supply voltages to things. On a 1998 car, when you push a window switch, it send current throught the switch to the electric motor in the door. On a 2005 car, a different switch sends a signal to a controller that s...