Bumping this really good thread started in 2011 on brake jobs I’ve found 30 seconds of propane heat free most anything on the brakes, caliper screws, bleeders, hoses. If you heat the hoses, you will need to replace them. It’s less about expanding the nut around the bolt, it is more the chemical chan...

Hopefully it will even out. But shuddering at idle shouldn't have anything to do with Tranny. That would most likely be motor mounts.

I was impressed. And they never dumped the fuel, which is interesting. Over a city, not high enough, no time? Or no need, as it was flying just fine on one engine as designed? But heavy, right, with a non-stop to Hawaii? Speaking as a layman here - The way that engine was shaking in the mounts, may...

abscate wrote: ↑25 Feb 2021, 05:34 “ try clearing the codes and take her up again”

It might be the ECU....

“ We couldn’t hear the noise”

“ They all sound like that from the factory”

“You need a new OXS Sensor and a MAF”

May Asymmetrically Fly

Cameron Pyzewski"s B8444S swap.

Egg crates for the crass , waterfall for class...

Got the Neptunes back on the wife's GLT with some fresh Nokian Z-Lines.

Wow. He is smoking something to pay 8k for a paint job.

bmdubya1198 wrote: ↑29 Mar 2021, 09:25 Duh... why the hell didn't I think of that? That would be the easiest way to do it, that's for sure. Hard drive is easy access on my laptop too.

On my old portable workstation I took the DVD drive out and replaced it with Hard Drive Caddy and second hard. Set it up for dual boot.