Replace it and leave it. Your Car will be happier with temp control on the inlet air

In Oakland CA: replace it and then pull it back off after inspection. You can get one at any auto parts store, just generic flex tubing like that in the exhaust parts section. It feels/looks like a metal-lined cardboard, about $12. Your car will be happier with cooler air most of the time, than with...

The deal with SAS and CA cars is that if the tech knows what they are doing somewhat, and do their job of looking for the emissions sticker and checking if the equipment is all there, then you will fail by completing the SAS delete. The air pump won't be hooked up, vacuum tubing removed. It used to ...

Isn’t there also a fix of putting a drain hole in the pump to remove water?

The filter (#16) is Volvo part number 3538564.
If you cannot find the filter ... Lawn mower inline fuel filter.

You might want to take a look at #21 the Air vent valve.

Click on picture to zoom in.

Air pump works for a few seconds after starting a cold engine and sometimes at prolonged idle when ecu ask for it. You can delete SAS and still pass inspection with soldering a diode in ecu and leave everything as it is. If your problem is SAS valve,you can also block it and leave all components in ...

1) I still need to check that the air pump is, in fact, working. Should I do this with the hood open and have my wife start the car while I listen for something in the vicinity below the battery? 2) Is there a good diagram of how the air pump and its various hoses/valves/wires should look in the en...

I'm impressed that the SAS trouble code was the first one you've had on a 22 year old car -- super reliability!!
Could the lack of a chime at start up be due to a worn out electrical portion of the ignitiion switch?

This thread may help a little viewtopic.php?f=1&t=89332

You can empty it into a friends car by cracking the union at the fuel rail and using fuel hose to route it to the empty fuel tank

Empty the first two gallons into a gas can for your trip.

Jump the fuel relay with a. Piece of wire to pump gas. It will take 20-30 minutes to empty a full tank