For flushing, just use the transmission itself to pump out the fluid and then fill up with new(same amount), repeat until reasonably clean. I also drain it before starting this, not sure if it is needed. There are a bunch of videos on yt on how to do it, I just connect hoses on the line that goes to...

I haven't driven the R that much the past year and I noticed the other day that it shifts kinda rough from 3 to 4 and also shudders when engaging reverse. One time it didn't fully disengage when coming to a full stop and took off harshly after hitting the gas pedal. Because it has not been worked m...

You are going to Vent gas fumes into Mother Nature and she will angrily set a code for an evap error in retaliation

I would say " Yes ". That little o-ring needs to be replaced. Tad bit easier than splitting the block.

1. Get get some Tracer dye and a UV light. 2. Power wash the engine clean. If you don't have a power washer, Car washes have setting for this task. 3. Add the tracer dye to the oil. 4. Drive it for a short while back to home. 5. Trace the leak back to the source with the UV light. The idea is to dri...

Lifting a '99 V70 Xc?

Too heavy. Don't try it, you'll hurt your back.

There used to be an entire "sealing kit" available for
the whole roof. Don't know if it's still available...

The clips should have a seal under them. If they are still good then it should not leak.

Neil.

Please read if you are truly interested in unintended consequences of MoS2... I have not tried MoS2 (molybdenum disulfide / molybdenum disulphide) additives in a volvo yet, but I have some knowledge of undesirable effects and potential effects in another car. Firstly, there are many comments on the ...