Search found 104 matches
- 13 Feb 2018, 21:40
- Jump to forum
- Jump to topic
Re: ATP-205 works!
I left my ATP near my cell and it turned into ADP plus energy. Some guy named Krebs came and fixed it back though.
- 22 Feb 2018, 20:44
- Jump to forum
- Jump to topic
- 24 Feb 2018, 16:42
- Jump to forum
- Jump to topic
Re: S70 Turbo: Returning Airbox to Stock Questions?
I just measured the O ring on a 98: it is 70 mm ID, and 5.5 mm thickness. I think you've got the right part number, e.g. you can see it tucked away in the illustration here https://www.jimellisvolvoparts.com/showAssembly.aspx?ukey_assembly=1060515&ukey_make=1099&ukey_model=16023&ukey_cat...
- 24 Feb 2018, 17:03
- Jump to forum
- Jump to topic
Re: Stereo Lighting Half Out
Multi-CD changer was usually mounted to the underside of the rear parcel tray in the trunk just forward of the trunk lid. I have pulled many amps from T5's at PnP. May have mostly come fitted with them (possibly). The cable is now obsolete so don't damage it. If it was fitted you should see the cabl...
- 24 Feb 2018, 17:28
- Jump to forum
- Jump to topic
Re: S70 Turbo: Returning Airbox to Stock Questions?
Looking at tat part it fits under the electrical connector on the MAF from the drawing. It is not a large diameter 'O' ring that fits in the hole in the air-box where the MAF attaches. I have even pulled the old hard copy parts listing and there is no 'O' ring listed that I can find. If the ID is 70...
- 24 Feb 2018, 19:23
- Jump to forum
- Jump to topic
Re: S70 Turbo: Returning Airbox to Stock Questions?
I was looking at the diagram wrong, I think Neil is right. See, https://www.jimellisvolvoparts.com/p/Volvo__V70-XC-5DRS-WO-SR/O-ring/7139918/3524462.html, correct part number is more likely Volvo 3524462. I just measured it at 81 mm, Neil's math checks out. All measurements are with calipers. Here a...
- 25 Feb 2018, 20:10
- Jump to forum
- Jump to topic
Re: S70 Turbo: Returning Airbox to Stock Questions?
I just put the calipers on a 98 MAF and it is 70 mm OD, so yes the air box hole it fits into (with the o-ring installed) is probably 80 mm ID. I'm all done measuring though!
- 15 Apr 2018, 13:20
- Jump to forum
- Jump to topic
Re: Hot day rough start
Check the engine coolant temperature sensor , or ECT for the correct resistance
You can search under its part number for threads, 9186486
You can search under its part number for threads, 9186486
- 15 Apr 2018, 19:48
- Jump to forum
- Jump to topic
Re: Alignment after shocks
True, eccentric bolts will allow for camber adjustment so there is fodder for discussion there, but there is no use for them in a stock and reasonably well maintained setup. Really? Because every alignment shop I've been to says they adjusted the camber. They also say the rear-end alignment is non-a...
- 18 Apr 2018, 23:50
- Jump to forum
- Jump to topic
Re: Crazy Overboosting
If sou Really Think you are getting 20 psi start with wastegate Adjustment to Factory Settings. In 1st gear boost is Limited by the ecu or TCM. In 4th it might be geared too long for overboost







