It was a good day to do INDOOR plumbing. Strong North wind and a high of 32 F. Yesterday I worked about 5 hours on the second bathroom sink, drain, supply hoses, and faucet replacement. I knew I did not have everything needed for the drains, but planned to replace the drain another day. Murphy said ...

I ordered up some new GKN Loebro axles for the XC. A little history; my originals failed at 240,000 Kms, I then tried 2 sets of Cardone China specials with bad results (vibration right out of the box), then got a nice set of used originals (GKN) from the auto wreckers that have been working well for...

Finally got " Tab A " inserted into " Slot B ". So far, so good. I MIGHT have it all buttoned up this weekend, but I kind of doubt it.

I ordered up some new GKN Loebro axles for the XC. A little history; my originals failed at 240,000 Kms, I then tried 2 sets of Cardone China specials with bad results (vibration right out of the box), then got a nice set of used originals (GKN) from the auto wreckers that have been working well fo...

I suppose it’s an intentional design, like the banjo bolt - keeps things interesting for us loyal folk who like DIYing ;) Nope, I don’t send anything anywhere. You need 1. A laptop, 2. Internet connection, 3. DiCE unit (ViDA software not needed nor is it used in this case). You provide him your VIN,...

Hopefully I can provide some guidance for this job for those who are contemplating a DIY, it's a very easy job that shouldn't take more than 2 hours for both sides. I will also address my technique for removing the often intimidating driver's side axle successfully as there are countless forum threa...

Hey Matthew, I've always liked the Chargers but never really considered ownership due to admission costs, and I'm incredibly fussy about condition and thought that something I would be satisfied with would be well over 100K. Anyway, this car came available from the widow of the original owner and wa...

All done! We did 3 new keys. In addition to this, for my original switchblade that I broke the transponder for, we re-coded a new Id48 chip so that switchblade is now functional again. All in all, it took a little under an hour to do 3x keyless entry programming and 4x immobilizer transponders (ID48...