I got a good deal on a matched set. My v70xc came with 15s and I have 225 55 16 nordicfrosts on now I think this option is the best of the three thanks for the input

I know the 205 R16 is more standard size, I wondered if anyone had some experience with a 195 55 16 size?

Thanks

nevermind i found it 9445857 i should start calling it a torque tube. http://www.volvopartswebstore.com/showA ... ct=1177577

Does anyone know the part number for the viscous coupler bearing 1999 v70xc. I would like to replace mine as it growls at low speeds, increasing pitch up with speed. I already have new rear wheel bearings tyvm.

Can I get some recommendations for a wind deflector fairing for in front of my thule roof rack. Its the square rack with a 599 bike mount. I switch out in the winter for the ski/snowboard. Pics help too
Thanks

Thanks for the replys, I remember working on a car in the past, maybe one of my old trucks, that had a heavy flap that unbolted and rolled up out of the way. I was thinking of desigining somethinkg like that with some ptfe coated fabric, but the angles are awkward and may still rub and with seams, c...

Hi all, A lot of work is done on our cars thru the passenger side wheel well where we remove a couple black plastic nuts and peel back the fender liner. Over time and servicing motor mounts, timing belts, water pumps etc that plastic liner is deformed and usually not able to be held down as tight as...

Had the same clicking noise in my 99 v70xc awd took out driveshaft no more clicking, front cv boot was gone and grease all up in the driveshaft tunnel. wish i could rebuild this one but off to denver with it.

Last night I finished final tuning on my B5254T motor swap. Initial performance was sluggish especially from dead stop. Checked MAF, vacuum leaks all good, so I rechecked timing belt alignment. Its hard to tell perfect alignment because you always look at some angle over the fender and pictures real...

After VVT and ETM swap she fired up and ran much better. RPM's hold right at 900 Idle. After about 15 minutes it seemed the ECM made some adjustments and runs very smooth now. I dont know if there is a customary break in period when engine and electricals are changed as I did. It is amazing how I fe...