This has been resolved. I left them finger tight then reassembeld the whole back end, dampers springs delta mounts I loaded the rear suspension to normal ride height and marked the bush relative to each transverse arm with a line of paint I then stripped everything again and swung both arms out and ...

circled red is bolt in question

Circled in red is the bolt which i require assistance to torque up,

There is no access to the bolt once each mount is in place inside the rear subframe.

I can torque up the bolt with the arms pulled out but what position do they sit in as they spin on the mounting.

Thanks all

Hi thanks but its the Rear control arm bushes that I have replaced, the two transverse arms run left to right and they enter into the alloy bodied bush

where they enter into the bush theres a bolt but theres no access once fitted in, how do you get them into correct position to torque up?

Thanks!

Hi I have removed the two alloy bodied control arm bushes from the car and ready to refit the new ones.

How to I know where the bush sits relative to the arm to torque it up?

Once refitted its hard to get to the bolts.

Thanks