I am not a Mechanic but if injector 1 is not getting any signal then how can the cam sensor be a problem? The only code I get is the O2 sensor.

Update: Report from Machanic: "Eng missing on #1 #2 #4. Pluggs, Coils Injectors ok, compression ok, no signal from computer on injectors." The tech also said he had 2 other earlier 960's that were inline engines that had similar problems and is hinting it could be a problem with either equ...

I took my 92 960 Volvo to a wrench who has a good amount of experience with volvos. He has confirmed my fuel injection timing is not correct and has determined that this is a computer issue as everything else on the car has been cleared. Ignition coils are fine, injectors are fine, compression is fi...

Also, I have the engine mounts installed, but I feel a LOT more engine vibration and hear a lot more engine noise then I did with the old mounts. The people I purchased the mounts from said this is to be expected with new mounts and it will become more quiet once the mounts are broken in. Is this tr...

I just found the paperwork from my dad (previous owner) who kept very good care of the car and handed over all documentation and repair information he had on the car. The fuel filter was replaced at 157k, there is 164k on the car right now. Whats next on the list to check?

Bill: Think it's the sensor or should I look at the fuel filter & fuel pump?

There's two O2 sensors. The codes can't be exact enough to tell you if your fuel pump is leaning the fuel to your motor due to wear or a blocked filter. I would look into fuel pump so we are still steering back to pump & filter. Didn't get a response from you of trying to spray cold water on th...

Use this link to obtain the PDF: http://precisioncopiers.com.au/Volvo/900_EngineOBDCodes.pdf This should help you get the codes Plug choice is very critical for this series of engine. If you can go with OEM you'd be better off. Thank you Mike! It came back with 2-3-2 error code which according to t...

I didn't think this car had an OBD II port on it. I found something on the driver side next to the fender. It has 6 plugs that are round and has the letter A on it. Does the 1992 960 have a ODB II port on it?

I got the engine mounts replaced. The tech said that both were going bad. After they were replaced the check engine light came on. According to the tech he said that my engine is misfiring and that is causing the engine to continue to physically move. It's not as bad as before but it's still noticea...